So, I'm not sure it that is, indeed, the oil port. As stated above, I saw a small opening it was not covered with a cap or plug. Error codes will not show on the remote thermostat even when in remote thermostat. Perhaps I need to remove the fan from the motor to see the port on that side.Ĭan anyone confirm how this procedure is done? The manual also says, "Replace the dust cap or plugs on oil ports, after adding the oil. Rinnai direct-vent appliance must be installed by a state qualified or.
![rinnai energysaver 1004f error codes rinnai energysaver 1004f error codes](https://us.v-cdn.net/5021738/uploads/editor/b7/tcmvcuxa0hco.jpeg)
So, apparently, there's a port at both ends. "Use a good grade of SAE 20 nondetergent motor oil and put one teaspoon, or about 16 to 25 drops, in each oil port. The furnace is a Carrier, model 58GP, GS. But, as I recall, I did not see the same type of opening on the other end, which is the end to which the fan is connected. This heater must not be installed where curtains or other combustible materials could come into contact with it. For information on gas type, see data plate on the appliance. On one end of the motor, I saw a small opening on top of the shaft bearing which appeared to be an oil receptacle. The installation must conform with local codes or, in absence of local codes, the National Fuel Gas Code, ANSI Z223.1 or the Canadian Installation Code, CAN/CGA-B149.
![rinnai energysaver 1004f error codes rinnai energysaver 1004f error codes](https://www.jetsetplumbing.com.au/images/rinnai-error-codes.png)
I have turned it on/off a number of times, as recommended to see if it fires again no luck. Rinnai Rinnai error code 10 indicates that the air supply or exhaust system is.
Rinnai energysaver 1004f error codes how to#
I pulled the fan assembly out once last year to examine it and try to see how to lub the motor. I have a rinnai energysaver 1004F that has just sent an error cod of 53. As I recall, the manual also does not say what type of oil should be used. The manual to my furnace says the fan motor should be lubricated at certain intervals but contains no illustrations on how to do that.